<tt id="gasy0"></tt>
  • <bdo id="gasy0"></bdo>
  • <xmp id="gasy0">
    <tbody id="gasy0"></tbody>
    <rt id="gasy0"></rt>
  • <tbody id="gasy0"></tbody>
  • <input id="gasy0"><blockquote id="gasy0"></blockquote></input>
  • Are levelers restricted?
    Are levelers restricted?
    News Source:   2018-12-20 14:00:08

    The use of leveling machine is not too limited, as long as the tension and narrowing (size tolerance changes are acceptable) can be used. Leveling machine is suitable for cold working materials after softening annealing (similar to softening annealing), because softening annealing can eliminate internal stress, and some tension annealing can improve the shape of the plate. After cold working, the shape of the plate may deteriorate or the internal stress may regroup. At this time, stretch bending can improve the shape of the plate and eliminate the L internal stress.

    2. Usually, the stress relief annealing is decided by the customer's requirement and the shape change of the products of our company. Most of our products are directly shipped separately after stretching and straightening. Only IC chips are made, and materials using etching method need stress relief annealing. Soft or heat-treated (stress relief annealing) materials usually do not need to be stretched and bended, because after stretching and straightening, the shape of the plate is flat, but the internal stress will regroup, and the worse the shape of the incoming plate, the greater the residual stress after stretching and straightening, the stress relief annealing must be carried out again.

     

    3. Extrusion process is different, if it is hot extrusion, the phenomenon of eliminating internal stress has occurred in the extrusion process, so distortion and bending have been finalized, and then after stretching and leveling, residual stress will be generated again, so whether heat treatment is needed, you judge by yourself, and judge according to customer needs. As the process is not well understood, further analysis is needed. It's a thick belt. It can only be leveled by roll. In my opinion, it's a thin belt. It's a roll leveling plus tension leveling.

    Extrusion process is different, if it is hot extrusion, the phenomenon of eliminating internal stress has occurred in the extrusion process, so distortion and bending have been finalized, and then after stretching and leveling, residual stress will be generated again, so whether heat treatment is needed.

    <tt id="gasy0"></tt>
  • <bdo id="gasy0"></bdo>
  • <xmp id="gasy0">
    <tbody id="gasy0"></tbody>
    <rt id="gasy0"></rt>
  • <tbody id="gasy0"></tbody>
  • <input id="gasy0"><blockquote id="gasy0"></blockquote></input>
  • 小说娇妻拍a片被弄大了肚子_中国老妇女毛茸茸bbwbabes_国产a精彩视频精品视频下载_啪啪呦女网站呦齿